Fiery Command WorkStation

Fiery JobMaster-Fiery Impose-Fiery Compose

Hide or show navigationPrevious topicNext topicSharePrintPDF

Specify settings to create a finisher preset

You must specify settings in the Finisher Preset window to create a preset. For more information, see Specifying settings in the Finisher Preset window.
  1. Select a spooled job in the Held list in Command WorkStation and open Fiery Impose in one of the following ways:
    • Select Impose from the Actions menu.
    • Right-click the job and select Impose.
  2. In the Settings pane, click Finisher Preset to open the Finisher Preset window.
  3. Click View available modules to display the number of modules specified for your finisher options. The Finisher model displays the name of the finisher that you have specified in Edit > Preferences > Finishers > Select device. For more information, see Set finisher preferences.
  4. To create a preset, do one of the following:
    • Select New preset from the Finisher preset list.
    • Click Create new using to create a new preset from an existing preset.
    Note the following:
    • This feature is currently supported depending on your finisher.
    • You can choose existing presets from the Finisher preset list. For more information, see Apply an existing preset.
  5. In Job/barcode number, specify the number that corresponds to barcodes that can be displayed on the sheet.
    Note: Barcodes are finisher dependent.

    You can view the barcode range in the status bar at the bottom. When you create a new preset, the next sequential number is automatically assigned to the preset.

  6. In Setup, specify the number of horizontal perforation modules in the list on the left and the number of vertical perforation modules in the list on the right.

    Due to the number of slots available on the finisher, if you specify the horizontal perforation as 1, for example, you can select only 1 as the vertical perforation module. However, if the job does not require horizontal perforation, select 0 in the horizontal perforation list and you can use up to 2 vertical perforation modules. Select 0 in both horizontal and vertical perforation lists if the job does not require perforations. The number of available slots depends on your finisher. The number of vertical perforations possible depends on whether any horizontal operation is required.

    Depending on your selected finisher, you can select one of the following horizontal perforations:
    • Horizontal perforation (CPM)
    • Horizontal crease up (CRM)

    Crease up and perforation cannot be used at the same time.

    Note: For vertical perforation, the maximum number of modules available for use is determined by the values that you specify for PFM and RTM in Fiery Impose > Edit > Preferences > Finishers. For more information on PFM and RTM, see Set finisher preferences.
Parent topic: Create a finisher preset