After you have successfully measured the patch page provided for the total ink limit, the results are displayed and you can make some adjustments.

1. Choose one of the following:
   • Choose a value for the total ink limit.

     The value displayed is the value suggested for your press without additional measurements required. You can enter a numerical value of your choosing should you decide not to use the suggested value.

   • Choose a value from a printed visual chart.

     The value displayed is the value suggested for your press based on a specific column number in the chart. You can select a column number of your choosing should you decide not to use the suggested value. The printed visual chart may reveal issues that measurements alone cannot detect. For instance, ink might seep through the substrate if too much is allowed. In this case, you will want to use a lower value than the suggested one.

2. Optional: Print a visual chart.

   The Patch Layout window in FieryMeasure is displayed. Click Print to continue.

3. Click Print Benchmark.