Fiery Command WorkStation

Fiery JobMaster-Fiery Impose-Fiery Compose

Hide or show navigationPrevious topicNext topicSharePrintPDF

Specifying settings in the Finisher Preset window

To create a finisher preset, open a spooled job in Fiery Impose, and specify settings in the Finisher Preset window. In the Finisher Preset winow, you can specify settings in three tabs: Layout settings, Crease, and Perforation.

Note the following:
  • The applicable range of each setting that you specify is displayed in the status bar at the bottom of the Finisher Preset window.
  • When you specify a setting in the Finisher Preset window, you can preview the changes in the Sheet View pane. If you do not specify the settings in the Finisher Preset window, default values are automatically set.
  • You can navigate between settings and tabs sequentially. However, if you return to a previous setting or tab, all values and settings that you specified revert to default values.
  • Diagnostic information, such as informational and warning messages, is displayed at the bottom of the Settings pane.

You can specify settings in the Finisher Preset dialog box using the following controls:

Item Description
Finisher model

View the name and model of the finisher that you have specified in Fiery Impose > Edit > Preferences > Finishers > Select device.

Click View available modules to display the number of modules specified for CPM, PFM, and RTM. For more information, see Set finisher preferences.
Finisher preset Select New preset or click Create new using to create a new preset from an existing preset. Existing presets are also available in this list. For more information, see Apply an existing preset.
Note: Creating a finisher preset is supported only on some finishers.
Job/barcode number Specify the number that corresponds to barcodes that can be displayed on the sheet. When a new preset is created, the next available sequential number is automatically assigned to the preset.
Note: Barcodes are finisher dependent.
Setup Specify the number of horizontal perforation modules in the list on the left and the number of vertical perforation modules in the list on the right.
Note: This option is available depending on your finisher.
Layout settings tab Specify the layout settings of the finisher preset. For more information, see Specify settings in the Layout settings tab.
Crease tab Specify the number of creases. For more information, see Specify settings in the Crease tab.
Perforation tab Specify the number of horizontal and vertical perforations. Additionally, define patterns and segments that can be applied to each perforation. For more information, see Specify settings in the Perforation tab.
Status bar View the valid range of each setting at the bottom of the dia- log box. You must enter a value within the valid range to be able to proceed to the next setting.
Arrows

Navigate between settings in tabs using the arrow keys on the keyboard.

Alternatively, use the Tab key to navigate to the next setting and Shift+Tab to return to previous settings.
Next and Back buttons Navigate between tabs.
Apply button Apply the settings to the job.
Note: Apply does not publish the layout as a preset. After the layout is applied to the job, you can select Clear layout or Publish in the Settings pane.
Apply & Publish button Perform both Apply and Publish functions with one click. Apply & Publish appears in the Perforation tab. Specify settings in the Publish layout window and click Publish to generate a finisher preset based on the settings. This finisher preset is then exported to the Duplo PC Controller computer.
Parent topic: Create a finisher preset