Fiery Command WorkStation

Fiery JobMaster-Fiery Impose-Fiery Compose

Hide or show navigationPrevious topicNext topicSharePrintPDF

Specify Vertical perforation

  1. In Module type, select PFM or RTM depending on the type of job.
  2. In PFM L/R or RTM L/R, select the type of perforation to be applied on the left and right side of the sheet.
    Note: For RTM, after you specify perforations on the right and left, No of vertical perforation and Segments are automatically set to 1. You can change these values as required.
  3. In No of vertical perforation, select the number of vertical perforations required by the job. When you select the number of vertical perforations, the Pattern definition settings are displayed. Note the following:
    • PFM supports only one continuous vertical perforation on the left and right side of the sheet.
    • For RTM, depending on the number of vertical perforations that you selected, corresponding rows of pattern definitions are displayed.
  4. In Pattern definition, define the position of the vertical perforation. Positions of right and left perforations are calculated from the right edge of the finish size.
    • In X1R and X1L settings, define the position of the perforation on the right and left side of the sheet.
      Note: PFM supports only one vertical perforation.
    • For RTM, specify the X position of each perforation on the right and left side of the sheet depending on the number of vertical perforations that you selected in No of vertical perforation.

    For RTM, specify the following additional settings:

    • Segments: Specify the number of segments required in the vertical perforation.
    • Position: Specify the starting and ending position of each segment of the perforation. Position is calculated from the leading edge of the finish size. Depending on the number of segments selected, a corresponding number of position settings are displayed.
    Note: Only RTM can perform segmented perforation.
Parent topic: Vertical perforation