Use the Trim tab to set trim marks.

1. Click the Trim tab.
2. Select the Print trim marks checkbox.
3. Select from the Style menu:
   • Standard - Prints the marks in a standard western style format (single marks at the corners). This is the default setting.
   • Japanese - Prints marks in a Japanese style format (marks at the corner and in the center of each side of the page).

     If the bleed value is 0, the Japanese marks are one line, similar to the standard style. If a bleed value is set, two corner marks are displayed, to indicate the trim and the bleed.

     Note: Jobs using Japanese marks can be saved only as flattened PDF jobs, not as .dbp format. Templates saved using Japanese marks can only be used within Fiery impose.
4. Set the following for the printed trim marks:

   • Set the horizontal and vertical mark length from 1 to 216 points.

   • Set dotted or solid for Stroke type.

   • Set Stroke width from 1/4 to 3 points.

   • Set Stroke color.

   • In the horizontal and vertical Offset fields, enter values from –72 to +72 points, –1.0 to 1.0 inch, or –25.4 to 25.4 mm.