Measure with Epson SD-10

You can measure color patches on a page using the Epson SD-10 spectrophotometer.

When you select the SD-10 as your measurement method, you can set the instrument settings:

Measurement mode - Select the type of measurement that you want. You measure each strip in one pass.
- M0 - One pass, UV included
- M1 - One pass, D50, UV included
- M2 - One pass, UV cut

When a page has been successfully measured, you can check the measurements. If any measurements are not as expected, you can remeasure the strip.

Place the patch page on a smooth, even surface.
Place the SD-10 on the first patch of the first strip, aligning it with the white positioning line.
Press the button twice until the SD-10 beeps and displays a message.
Slide the device along the strip of patches slowly and at an even pace until the SD-10 reaches the white space at the end.
After you successfully measure one strip of patches, move the SD-10 to the first patch of the next strip, aligning it with the white positioning line.
Continue to measure the remaining strips in the same manner until you have measured all patches on the page.
Continue to measure the remaining patch pages (if any) in the same manner until you have measured all patch pages.
After you measure the last page, click Next.