Fiery Command WorkStation

Fiery Command WorkStation

Hide or show navigationPrevious topicNext topicSharePrintPDF

Measure with i1iO 2

The i1iO 2 automatically moves the ES-2000 over each row of patches to measure them. The on-screen image highlights each row as it is measured.

Before measuring patch pages, you must calibrate the ES-2000 that is connected to the i1iO 2. The ES-2000 is calibrated to the white tile on the i1iO 2. Calibration may fail if the white tile is covered or is not clean.

When you select the i1iO 2 as your measurement method, you can set the patch size to one of the available sizes: Normal (Default), Medium, and Large. The measurement method is the same for all patches regardless of patch size.

When you have successfully measured a page, you can check the measurements.

  1. Place the first patch page on the i1iO 2, and then click Next.

    Position the page with the top edge closest to the i1iO 2 arm.

    Note: You can switch from scan measurements to scan to spot measurements, and back to scan measurements as a per row decision for both a chart and a wedge.
  2. Following the on-screen instructions, position the crosshairs over the patch marked A and press the button on the ES-2000. Repeat for the patches marked B and C.

    The on-screen image helps you locate the patches A, B, and C.

  3. Click Next.
  4. When i1iO 2 finishes measuring the page, click Next.
  5. Measure the remaining patch pages (if any) in the same manner as the first, starting with the placement of the page and the registration of patches A, B, and C.
  6. After you measure the last page, click Next.
Parent topic: Measuring a measurement page
Related topics:
Check measurements after you measure a page