Measure with i1iO3

The i1iO3 automatically moves the ES-3000 over each row of patches to measure them. The on-screen image highlights each row as it is measured.

Before measuring patch pages, you must calibrate the ES-3000 that is connected to the i1iO3. The ES-3000 is calibrated to the white tile on the i1iO3. Calibration may fail if the white tile is covered or is not clean.

When you have successfully measured a page, you can check the measurements.

Place the first patch page on the i1iO3, and then click Next.
Position the page with the top edge closest to the i1iO3 arm.
Following the on-screen instructions, position the crosshairs over the patch marked A and press the button on the ES-3000. Repeat for the patches marked B and C.
The on-screen image helps you locate the patches A, B, and C.
Click Next.
When i1iO3 finishes measuring the page, click Next.
Measure the remaining patch pages (if any) in the same manner as the first, starting with the placement of the page and the registration of patches A, B, and C.
After you measure the last page, click Next.