Access Configure

After you start the Fiery server for the first time, or install system software, you must set up the Fiery server. If you do not, default settings are used. Make sure that settings are appropriate for your printing environment. If your network or printing environment changes, you may need to adjust your settings.

You can set up the Fiery server from a client computer using Configure, which you can access from the following locations:

Command WorkStation
WebTools (with a supported Internet browser)

Access Configure from Command WorkStation

From Command WorkStation, connect to the desired Fiery server and log in as Administrator.
Do one of the following to start Configure:
- In Device Center, select General Info, then click Configure in the lower right corner.
- In the Server menu, click Configure.
From Configure, change current Fiery server setup options.

Access Configure from WebTools

Use Configure to set up the Fiery server. Setup is required the first time the Fiery server is turned on or after system software is installed. You also use Configure to specify information about the network environment and printing preferences for jobs that users send to the Fiery server.

Open an Internet browser and type the IP address of the Fiery server.
In WebTools, click the Configure tab.
Note: If you receive a message about untrusted connections, you can ignore the message and proceed anyway.
Log on with Administrator privileges.

Locate Help and other information about Configure

In Configure, click the Help icon on the right side of the screen.

For information about setup options in Configure that are not discussed in this Help or Configure Help, see Configuration and Setup, which is part of the user documentation set.

Note: Some Configure options may not be supported by your Fiery server.