When you measure color patches in ColorCal, use the gray scale strip along
with the ColorCal calibration page that you printed. The gray scale strip is included in the
customer media pack that came with your Fiery server.
Measure the ColorCal calibration page after
you prepare the scanner, unless you skipped scanner preparation.
- If you have just prepared the scanner, remove
the ColorCal Scanner page and the color control patches strip.
- Place the gray scale strip face down on the glass (platen).
Place the strip along the top edge of the glass (platen) and center
it along the top edge of the calibration page.
- Place the ColorCal Calibration page face down over the
gray scale strip.
Make sure that the patches on the gray scale strip do not
overlap the color patches on the ColorCal Calibration page.
- Close the platen glass cover, being careful not to move
the gray scale strip and ColorCal Calibration page.
- Click Continue to
start the ColorCal measurement.
- When the measurement is complete, click OK to view the measurement
results.
