Enable PrintMe cloud printing

When you enable PrintMe, you may need to specify information about the proxy server.

Important: There are two versions of Configure and they are specific to the Fiery Server you are connected to. This is a combined procedure that describes what to do when connected to a Fiery Server with FS100/100Pro or earlier, and notes about what to do with FS150/150 Pro or later. If you are not sure which version of Configure you are using, see Which version of Configure am I using?.

From Configure, choose PrintMe.
Note: If you are connected to a Fiery Server with FS150/150Pro, you can find settings mentioned in this procedure in Job Submission > PrintMe instead.
Click Enable PrintMe.
If your Fiery Server uses a proxy server on your network, click Proxy Settings.
Note: If you are connected to a Fiery Server with FS150/150Pro, click the Manage link instead.
Click Enable Proxy.
Note: If you are connected to a Fiery Server with FS150/150Pro, select Enable HTTP Proxy instead.
Type the information about the proxy server, and click Save.
Apply or save your changes.