After you have successfully measured the patch page provided for the total
ink limit, the results are displayed and you can make some adjustments.
-
Choose one of the
following:
- Choose a value for the
total ink limit.
The value
displayed is the value suggested for your press without additional
measurements required. You can enter a numerical value of your choosing
should you decide not to use the suggested value.
- Choose a value from a
printed visual chart.
The
value displayed is the value suggested for your press based on a
specific column number in the chart. You can select a column number of
your choosing should you decide not to use the suggested value. The
printed visual chart may reveal issues that measurements alone cannot
detect. For instance, ink might seep through the substrate if too much
is allowed. In this case, you will want to use a lower value than the
suggested one.
-
Optional: Print a visual chart.
The Patch Layout window in FieryMeasure is displayed. Click Print to
continue.
-
Click Print
Benchmark.
Now watch the video on how to set the total ink limit here.
