Configure FS700

Hide or show navigationPrevious topicNext topicSharePrintPDF

Access Configure

After you start the Fiery server for the first time, or install system software, you must set up the Fiery server. If you do not, default settings are used. Make sure that the settings are appropriate for your printing environment. If your network or printing environment changes, you may need to adjust your settings.

When you use proxy servers with the default web browser, you may not be able to start Configure from Command WorkStation. Register the Fiery server IP address as an exception in the default browser settings. Verify your default browser connection settings and adjust them accordingly.

You can set up the Fiery server from a client computer using Configure, which you can access from the following locations:
  • Command WorkStation
  • WebTools (with a supported Internet browser)
Parent topic: Configuring Fiery server settings

Access Configure from Command WorkStation

  1. From Command WorkStation, connect to the desired Fiery server and log in as Administrator.
  2. Do one of the following to start Configure:

    • In the Server menu, click Configure.

    • In Device Center, select General Info, then click Configure in the lower-right corner.

  3. From Configure, change current Fiery server setup options.

Access Configure from WebTools

  1. Open an Internet browser and type the IP address of the Fiery server.
  2. In WebTools, click the Configure tab.
    Note: When you start Configure, the browser may display a security certificate error. You can safely proceed despite the error.
  3. Log on with Administrator privileges.