Before measuring measurement pages, be sure that the measurement instrument
is connected properly. Calibrate the instrument if instructed to do so.
Note: Patches may be bordered by rows of yellow
patches or black patches that allow the instrument to measure in either direction. The yellow
patches and black patches are not included in the measurement data.
- Place the first measurement page in or on the
instrument.
- If page registration is required, follow the on-screen
instructions to register the page location.
- If the instrument requires you to scan the patches manually,
follow the on-screen instructions to scan each strip.
Note: In some cases, an invalid measurement may be
detected even if you measured the correct strip. Measure the strip again to
confirm the correct strip was measured. The error message does not affect
the measurement process, and the measurement instrument will complete the
measurement
successfully.
- After you successfully measure a page, you can check
the measurements.
If any measurements are not as expected, you can remeasure the
strip if your instrument supports manual scanning.
- Continue to measure any remaining pages.
- After you measure the last page, click Next.
